Piston; Removal - Stihl MS 200 Service Manual

1
: Push the grommet (1) with short
circuit wire into its seat (arrow).
– Position the short circuit wire.
MS 200 (above left)
Connector with sleeve butts against
the grommet.
MS 200 T (above right)
Connector without sleeve, distance
from grommet
a = about 2.5 cm
1
: Pull short circuit wire connector
(1) through the hole (arrow) at the
opposite side.
MS 200, MS 200 T
1
– Fit the grommet (1) for the
ignition lead and short circuit
wire.
: Push the grommet (1) fully into
the hole and line it up so that the
notched opening for the short
circuit wire points to the cable
guide (arrow).
– Install the crankshaft and the
ignition lead, b 8.5.1
– Install the oil seals,
b 8.3
– Reassemble all other parts in the
reverse sequence.
Make sure the impulse hose is
properly fitted on the nipples of the
crankcase and handle housing.
– Tightening torques, b 3.5
8.6

Piston

8.6.1

Removal

Before removing the cylinder,
decide whether or not the
crankshaft has to be removed as
well, b 8.5
– Remove the cylinder, b 8.4
The assembly drift
1114 893 4700 can be pushed
through the installed snap ring.
Therefore, it is not necessary to
remove both snap rings in order to
remove and install the piston pin.
Remove the snap ring at the clutch
side of the piston.
: Use a suitable tool to grip the
snap ring at the recess (arrow)
and ease it out.
1
: Place the assembly drift (1)
1114 893 4700 in position.
41