Exposing The Cylinder - Stihl TS 400 Manual

STIHL TS 400
- Slide the rotary shaft seal over the
crankshaft stub with the open side
facing the crankcase.
• Press it into place with press
sleeve (1).
- Install flywheel, see chapter 6.5.
5.5

Exposing the cylinder

Check and repair the fuel supply,
carburetor, air filter and ignition
system before locating faults in the
engine.
Refer to the manual "Trouble-
shooting, standard repairs" for
troubleshooting procedures.
- Remove muffler, see chapter 5.1.
• Press cap in at bottom, slide
upwards and remove.
• Depress throttle trigger slightly
and draw throttle rod out of
trigger.
• Set choke lever to upward
position.
• Unscrew shroud screws.
Note: One of the screws is not
shown in the picture.
- Remove shroud.
• Remove spark plug terminal (1)
from spark plug.
• Remove ignition lead and stop
switch lead from mount (2).
18