Login Methods - HP A5830 Series Configuration Manual
Hide thumbs
Also See for A5830 Series:
- Configuration manual (280 pages) ,
- Command reference manual (249 pages) ,
- Configuration manual (207 pages)
Table of Contents
Advertisement
Login methods
Log in to the switch in the following ways:
Table 6 Login methods
Login method
CLI login
Web login
NMS login
Default state
Logging in
By default, log in to a device through the console port. The authentication mode
through the
is None (no username or password required). The user privilege level is 3.
console port
By default, you cannot log in to a device through Telnet. To do so, log in to the
device through the console port, and complete the following configuration:
1.
Enable the Telnet function.
Logging in
2.
Configure the IP address of the VLAN interface, and make sure that your
through Telnet
device and the Telnet client can reach each other (by default, the device does
not have an IP address.).
3.
Configure the authentication mode of VTY login users (password by default).
4.
Configure the user privilege level of VTY login users (0 by default).
By default, you cannot log in to a device through SSH. To do so, log in to the
device through the console port, and complete the following configuration:
5.
Enable the SSH function and configure SSH attributes.
6.
Configure the IP address of the VLAN interface, and make sure that your
Logging in
device and the SSH client can reach each other (by default, your device does
through SSH
not have an IP address.).
7.
Configure the authentication mode of VTY login users as scheme (password
by default).
8.
Configure the user privilege level of VTY login users (0 by default).
By default, you cannot log in to a device through web. To do so, log in to the
device through the console port, and complete the following configuration:
9.
Configure the IP address of the VLAN interface (by default, your device does
not have an IP address.).
10.
Configure a username and password for web login (not configured by
default).
11.
Configure the user privilege level for web login (not configured by default).
12.
Configure the web service type for web login (not configured by default).
By default, you cannot log in to a device through a network management system
(NMS). To do so, log in to the device through the console port, and complete the
following configuration:
13.
Configure the IP address of the VLAN interface, and make sure the device
and the NMS can reach each other (by default, your device does not have
an IP address.).
14.
Configure SNMP basic parameters.
20
Advertisement
Table of Contents
