Hotfix Configuration Example; Network Requirements - HP A5830 Series Configuration Manual

# Download file soft-version2.bin on the TFTP server to the master and subordinate.
<IRF> tftp 2.2.2.2 get soft-version2.bin
...
File will be transferred in binary mode
Downloading file from remote TFTP server, please wait............
TFTP: 10058752 bytes received in 141 second(s)
File downloaded successfully.
<IRF> tftp 2.2.2.2 get soft-version2.bin slot2#flash:/soft-version2.bin
# Specify file new-config.cfg as the startup configuration file for all members of the IRF fabric.
<IRF> startup saved-configuration new-config.cfg main
Please wait ...
Setting the master board ...
... Done!
Setting the slave board ...
Slot 2:
Set next configuration file successfully
# Specify file soft-version2.bin as the system software image to be used at the next boot of all members
of the IRF fabric.
<IRF> boot-loader file soft-version2.bin slot all main
This command will set the boot file of the specified board. Continue? [Y/N]:y
The specified file will be used as the main boot file at the next reboot on slot 1!
The specified file will be used as the main boot file at the next reboot on slot 2!
# Reboot the device. The software version is upgraded now.
<IRF> reboot
To check if the upgrade is successful after the device reboots, use display version.

Hotfix configuration example

Network requirements

The IRF fabric in this example consists of two member switches, the master and subordinate. The
•
software running on the member switches is having problems, and a hotfix is needed.
The patch files patch_mpu.bin and patch_lpu.bin are saved on the TFTP server.
•
The IRF fabric's IP address is 1.1.1.1/24, and the TFTP server's IP address is 2.2.2.2/24. The IRF
•
fabric and TFTP server can both reach each other.
Figure 39 Network diagram for configuring hotfix
113