HP A5830 Series Configuration Manual page 38

Task...
c.
8. Create a local user and enter
local user view
9. Set the authentication password
for the local user
10. Specify the command level of
the local user
11. Specify the service type for the
local user
12. Configure common settings for
console login
After enabling command authorization or command accounting, perform the following configuration to
make the function take effect:
Create a HWTACACS scheme, and specify the IP address of the authorization server and other
•
authorization parameters.
Reference the created HWTACACS scheme in the ISP domain.
•
For more information, see Security Configuration Guide.
When users adopt the scheme mode to log in to the device, the level of the commands that the users can
access depends on the user privilege level defined in the AAA scheme.
When the AAA scheme is local, the user privilege level is defined by the authorization-attribute
•
level level command.
When the AAA scheme is RADIUS or HWTACACS, the user privilege level is configured on the
•
RADIUS or HWTACACS server.
For more information about AAA, RADIUS, and HWTACACS, see Security Configuration Guide.
•
After the configuration, you are prompted to enter a login username and password when logging in to
the device through the console port. A prompt such as <HP> appears after you enter the password and
username and press Enter, as shown in
Command...
Exit to
system
quit
view.
local-user user-name
password { cipher |
simple } password
authorization-
attribute level level
service-type terminal
—
Figure 10.
31
Remarks
Configuration Guide.)
Required.
By default, no local user exists.
Required.
Optional.
By default, the command level is 0.
Required.
By default, no service type is specified.
Optional.
See "Configuring optional common settings for
console login."