HP A5830 Series Configuration Manual page 66

Task...
2. Enable SNMP agent
3. Create or update MIB view information
a.
4. Configur
e SNMP
NMS
access
right
b.
Follow these steps to configure SNMPv3 settings:
Task...
1. Enter system view.
2. Enable SNMP agent.
3. Configure an SNMP group
and specify its access right.
Configure
Directly
an SNMP
community.
Configure
an SNMP
group.
Indirectly
Add a user
to the
SNMP
group.
Command...
system-view
snmp-agent
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-
view read-view ] [ write-view
write-view ] [ notify-view notify-
view ] [ acl acl-number ]
Command...
snmp-agent
snmp-agent mib-view
{ excluded | included }
view-name oid-tree
[ mask mask-value ]
snmp-agent community
{ read | write }
community-name [ acl
acl-number | mib-view
view-name ]*
snmp-agent group { v1 |
v2c } group-name [ read-
view read-view ] [ write-
view write-view ]
[ notify-view notify-
view ] [ acl acl-number ]
snmp-agent usm-user
{ v1 | v2c } user-name
group-name [ acl acl-
number ]
Remarks
—
Optional.
Disabled by default.
enable SNMP agent with this
command or any command that
begins with snmp-agent.
Required.
By default, no SNMP group is
configured.
59
Remarks
Optional.
Disabled by default.
enable SNMP agent with
this command or any
command that begins with
snmp-agent.
Optional.
By default, the MIB view
name is ViewDefault and
OID is 1.
Required.
Use either approach.
The direction configuration
approach is for SNMPv1 or
SNMPv2c. The community
name configured on the
NMS should be consistent
with the username
configured on the agent.
The indirect configuration
approach is for SNMPv3.