HP A5830 Series Configuration Manual page 21

When users Telnet to the switch through VTY 1, they must enter username test and password 12345678.
After passing authentication, the users can only use level 0 commands. If the users want to use commands
of level 0, 1, 2 and 3 commands, the following configuration is required:
[Sysname-luser-test] authorization-attribute level 3
Configure the user privilege level under a user interface
If the user interface authentication mode is scheme, and SSH publickey authentication type (only a
•
username is needed for this authentication type) is adopted, the user privilege level of users logging
into the user interface is the user interface level.
If the user interface authentication mode is none or password, the user privilege level of users
•
logging into the user interface is the user interface level.
Follow these steps to configure the user privilege level under a user interface (SSH publickey
authentication type):
Task...
1. Configure
authentication
SSH users as publickey.
2. Enter system view.
3. Enter user interface view.
4. Configure
authentication mode for
any user who uses the
current user interface to
log in to the switch.
5. Configure
level for users that log in
through the current user
interface.
Follow these steps to configure the user privilege level under a user interface (none or password
authentication mode):
Task...
1. Enter system view.
2. Enter user interface view.
Command...
the
For more information, see
type for
Security Configuration Guide.
system-view
user-interface { first-num1 [ last-
num1 ] | vty first-num2 [ last-
num2 ] }
the
authentication-mode scheme
the privilege
user privilege level level
Command...
system-view
user-interface { first-num1 [ last-
num1 ] | { aux | vty } first-num2
[ last-num2 ] }
Remarks
Required if the SSH login mode is adopted,
and only username is needed during
authentication.
After the configuration, the authentication
mode of the corresponding user interface must
be set to scheme.
—
—
Required.
By default, the authentication mode for VTY
users is password, and no authentication is
needed for AUX users.
Optional.
By default, the user privilege level for users
logged in through the AUX user interface is 3,
and that for users logged in through the VTY
interfaces is 0.
Remarks
—
—
14