Task...
6.
Configure the user privilege
level for login users.
7.
Configure common settings
for VTY user interfaces.
When logging in to the device through Telnet again, perform the following steps:
Enter the login password. A prompt such as <HP> appears after you enter the correct password and
•
press Enter, as shown in
If "
•
All user interfaces are used, please try later!
concurrent login users exceed the maximum.
Figure 13 Configuration page
Configuring scheme authentication for Telnet login
Configuration prerequisites
Log in to the device.
By default, log in to the device through the console port without authentication, having user privilege level
3 after login. For information about logging in to the device with the default configuration, see
"Configuration
Configuration procedure
Task...
1.
Enter system view.
Command...
user privilege level level
—
Figure
13.
requirements."
" is displayed, the number of current
Command...
system-view
38
Remarks
Required.
0 by default.
Optional.
See
"Configuring common settings for
VTY user interfaces
(optional)."
Remarks
—