Table of Contents
Advertisement
Unlocking Access Areas
Within the menu [Device Para\Access level] access areas can be unlocked or locked (at the HMI).
Changing Passwords
Passwords can be changed at the device in menu [Device Para/Passwords] or by means of the Power-Port-E s oftware.
When you want to change a password, the existing one has to be entered firstly. The new password (up to 8 digits) is
then to be confirmed twice. Please proceed as follows:
In order to change the password please enter your old password by means of the Softkeys followed by pressing the
»OK«-key.
Enter the new password by means of the Softkeys and press the »OK«-key.
Afterwards enter the new password once again by means of the Softkeys and press the »OK«-key.
Deactivating Passwords during Commissioning
It is possible optionally to deactivate passwords during commissioning. It is not allowed to use this feature for other
purposes than commissioning. In order to deactivate the password protection replace the existing password with an
empty one for the corresponding access areas. All access authorizations (access areas) that are protected by an empty
password are unlocked permanent. That means, that all parameters and settings within those areas can be modified
without any further access authorization. It is no longer possible to change into the » Read Only-Lv0« level (the
protective device will also not fall back into this mode if the maximum edit time is expired (t-max-Edit).
A password must be a user-defined combination of the numerics
1, 2, 3 and 4.
All other characters and keys won´t be accepted.
You have to ensure that all passwords are activated again after the
commissioning. That means, that all access areas have to be protected by a
password that consists of 4 digits as minimum.
The manufacturer will not overtake any liability for any personal injuries or
damages that are caused by deactivated password protection.
EMR-5000
www.eaton.com
IM02602012E
372
Advertisement
Table of Contents
