Table of Contents
Advertisement
Name
RO-4Z X2.RO 3
RO-4Z X2.RO 4
RO-4Z X2.DISARMED!
RO-4Z X2.Outs forced
RO-4 X5.RO 1
RO-4 X5.RO 2
RO-4 X5.RO 3
RO-4 X5.RO 4
RO-4 X5.DISARMED!
RO-4 X5.Outs forced
AnIn[1].Broken wire
AnIn[1].Input forced
AnIn[2].Broken wire
AnIn[2].Input forced
FldC[1].Active
FldC[1].ExBlo
FldC[1].Blo TripCmd
FldC[1].ExBlo TripCmd
FldC[1].Pickup
FldC[1].Trip
FldC[1].TripCmd
FldC[1].ExBlo1-I
FldC[1].ExBlo2-I
FldC[1].ExBlo TripCmd-I
FldC[2].Active
FldC[2].ExBlo
FldC[2].Pickup
FldC[2].Alarm
FldC[2].ExBlo1-I
FldC[2].ExBlo2-I
Pres[1].Active
Pres[1].ExBlo
Description
Signal: Relay Output
Signal: Relay Output
Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
Signal: Relay Output
Signal: Relay Output
Signal: Relay Output
Signal: Relay Output
Signal: CAUTION! RELAYS DISARMED in order to safely perform maintenance while eliminating the risk of
taking an entire process off-line. (Note: Zone Interlocking and Supervision Contact cannot be disarmed). YOU
MUST ENSURE that the relays are ARMED AGAIN after maintenance
Signal: The State of at least one Relay Output has been set by force. That means that the state of at least one
Relay is forced and hence does not show the state of the assigned signals.
Signal: Broken wire. This signal is only valid, if the analog input is used in the 4..20 mA mode.
The value of analog Input has been set by force. That means that the value of the analog Input is forced and
does not represent the real measured value.
Signal: Broken wire. This signal is only valid, if the analog input is used in the 4..20 mA mode.
The value of analog Input has been set by force. That means that the value of the analog Input is forced and
does not represent the real measured value.
Signal: Active
Signal: External Blocking
Signal: Trip Command blocked
Signal: External Blocking of the Trip Command
Signal: Pickup
Signal: Trip
Signal: Trip Command
Module Input State: External Blocking1
Module Input State: External Blocking2
Module Input State: External Blocking of the Trip Command
Signal: Active
Signal: External Blocking
Signal: Pickup
Alarm
Module Input State: External Blocking1
Module Input State: External Blocking2
Signal: Active
Signal: External Blocking
www.eaton.com
EMR-5000
IM02602012E
1029
Advertisement
Table of Contents
