Running Network Diagnostics On The 7847I-E Using A Private Lan - Honeywell AlarmNet 7847i-E Installation And Setup Manual

Running Network Diagnostics on the 7847i-E using a Private LAN

The network diagnostic process tests the integrity of the links between the 7847i-E and the
7810iR-ent to which it should report.
To initiate the network diagnostics, press the [F] key on the 7720P.
NOTE: The test is performed ONLY if a physical link is detected. If no physical link is detected,
the test is aborted and the following is displayed:
If a physical link is detected, the diagnostics are performed.
progression of the test:
No Physical Link
Testing CSIP 1
Testing CSIP 1
Reached CSIP 1
Reached CSIP 1
Testing Service
CSIP 1
Service OK
Testing CSIP 2
Testing CSIP 2
Reached CSIP 2
Reached CSIP 2
Testing Service
CSIP 2
Service OK
Testing CSIP 3
Testing CSIP 3
Reached CSIP 3
The first step of the test traces the connection to CS IP
1.
A successful trace to CS IP 1 is indicated here. See
below for possible errors that may occur at this stage of
testing.
After a successful trace to CS IP 1, a test of the service
at CS IP 1 is performed. That is, the first test
determines if a message can reach 7810iR-ent; this test
determines if the connection point (CSIP) at the 7810iR-
ent knows what to do with the message once it receives
it.
The service at the 7810iR-ent on CS IP 1 is functioning.
See below for possible errors that may occur at this stage
of testing.
The first step of the test traces the connection to CS IP 2
at the 7810iR-ent.
A successful trace to CS IP 2 is indicated here. See
below for possible errors that may occur at this stage of
testing.
After a successful trace to CS IP 2, a test of the service
at CS IP 2 is performed. That is, the first test
determines if a message can reach the 7810iR-ent; this
test determines if the connection point (CSIP) at the
7810iR-ent knows what to do with the message once it
receives it.
The service at the 7810iR-ent on CS IP 2 is functioning.
See below for possible errors that may occur at this stage
of testing.
The first step of the test traces the connection to CS IP 3
at the 7810iR-ent.
A successful trace to CS IP 3 is indicated here. See
below for possible errors that may occur at this stage of
testing.
Section 6: Network Diagnostics
The following shows the
6-3