Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual page 94

Commissioning a project
6.10 Transferring a license key
Procedure
1. Open the "Automation License Manager".
2. Start the "Automation License Manager".
– PC without WinCC installation
– PC with WinCC installation
The "Automation License Manager" starts.
3. Select the "Connect HMI device" command in the "Edit > Connect Target System" menu.
The "Connect Target System" dialog is displayed.
4. Select the "device type" of your HMI device.
5. Select the "connection".
6. Configure the corresponding "connection parameters" in line with the selected connection
in the window of the same name.
7. Click "OK".
The connection to the HMI device is established. The connected HMI device is displayed
in the left area of the "Automation License Manager".
8. On the left, select the drive on which the license keys are located.
The license keys are shown on the right.
9. Select the required license keys.
10. Drag-and-drop the license keys to the HMI device.
The license keys are transferred to the HMI device.
To back up the HMI device license keys, drag-and-drop the license keys from the HMI
device to an available drive. License keys can also be removed from the HMI device with
drag-and-drop.
94
Open the "Automation License Manager" from the Windows start menu
Open the "Automation License Manager" from WinCC as follows:
Select the "Authorize/License" command in the "Online > HMI device maintenance"
menu.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB