Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual page 6

Preface
Note information highlighted as follows:
Note
A note contains important information on described products and their handling or on a
section of this documentation.
Names of the software
Configuration and runtime software have different names as follows:
● "WinCC (TIA Portal) V13", for example, refers to the configuration software.
The term "WinCC" is used in a general context. The full name is always used when it is
necessary to differentiate between different versions of the configuration software.
● "WinCC Runtime" refers to the runtime software that can run on HMI devices.
Names of the hardware
These operating instructions describe the new "Basic Panels 2nd Generation" which
replaces the current Basic Panels. The term "Basic Panel" is used synonymously for a
"Basic Panel 2nd Generation" in these instructions.
Trademarks
Names labeled with a ® symbol are registered trademarks of the Siemens AG. Other names
used in this documentation may be trademarks, the use of which by third parties for their
own purposes could violate the rights of the owner.
● HMI
● SIMATIC
● SIMATIC HMI
● WinCC
6
®
®
®
®
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB