Connecting The Power Supply - Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual

Procedure
1. Interconnect the functional earth
connection of the HMI device with
an equipotential bonding conductor,
cross-section 4 mm
2. Connect the equipotential bonding
conductor to the equipotential
bonding rail.
3.3.3

Connecting the power supply

Stripping the cable
Use power supply cables with a
maximum cross-section of 1.5 mm
1. Strip the ends of two power supply
cables to a length of 6 mm.
2. Attach cable sleeves to the bare
cable ends.
3. Install the end sleeves on the
cable ends using the crimp pliers.
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB
.
2
.
2
Mounting and connecting
3.3 Connecting the HMI device
29