Siemens SIMATIC HMI KTP400 Basic Operating Instructions Manual page 26

Mounting and connecting
3.2 Mounting the HMI device
Inserting the HMI device
1. Slide the labeling strip
into the device using
the guide, if available.
2. Insert the HMI device
into the mounting
cutout from the front.
Make sure that
protruding labeling
strips are not caught
between the mounting
cutout and HMI device.
Securing the HMI device with mounting clips
1. If mounting clips and grub screws are
available separately in the accessory
kit, insert a grub screw into the
mounting clip bore hole and turn it
several times.
2. Place the first mounting clip into the
corresponding cutout.
3. Fasten the mounting clip with a size 2
screwdriver. The maximum permitted
torque is 0.2 Nm.
4. Repeat steps 1 to 3 for all mounting
clips required to secure your HMI
device.
26
Basic Panels 2nd Generation
Operating Instructions, 10/2016, A5E33293231-AB