Table of Contents
Advertisement
PARTS REQUIRED:
x1
OO
1-1/2 x 2-1/2 x 69" (3,8 x 6,3 x 175,3 cm)
Attach temporary support OO as a ledger board flush under wall
4
panels for doors to rest on using 3" screws (Fig. A).
Center doors on panel seam as shown (Fig. B).
5
Check ledger board is still flush under panels.
Screw hinge boards into wall frame and floor using ten 3" screws as shown.
6
Make sure screws go into framing and floor (Fig. C, D).
7
Remove temporary supports and check doors open properly.
FINISH
You have finished installing your doors.
8
Fig. C
Angle 3" (7,6 cm)
Screw
Fig. D
Flush
against wall panels
Fig. A
OO
DOORS
x13
51
3" (7,6 cm)
OO
Seam
3/8"
(1 cm)
3" (7,6 cm)
Screws into the wall
support and floor frame.
Fig. B
Advertisement
Table of Contents
