Table of Contents
Advertisement
PARTS REQUIRED:
Place 48 x 84-3/4" panel onto side wall flush with bottom of 42 x 96" panel with primed side up, as shown.
4
Secure panel with 2" nails in three corners (Fig. E). Ensure the measurement between the panel edges are
the same along the entire length (Fig. B). Angle nails to hit floor frame (Fig. C).
5
Remove temporary ledger OO.
Nail lower edge of panel to floor using 2" nails 6" apart. Angle nail to hit floor frame (Fig. A).
6
7
Nail side wall panels to rafter and wall studs using 1-1/2" nails 6" apart as shown.
2" (5,1 cm)
Nail
Repeat Steps 1-7 to attach the opposite side panels.
8
FINISH
9
You have finished installing your side panels. Proceed to install SIDE WALL STUDS.
SIDE WALL PANELS (continued)
x45
1-1/2" (3,8 cm)
Fig. C
6"
(15,2 cm)
1-1/2" (3,2 cm)
Nails
Fig. A
x16
2" (5,1 cm)
Fig. E
1-1/2" Nails
Flush
2" Nail
OO
6"
(15,2 cm)
2" (5,1 cm)
Nails
30
Primed
side up
Same
Measurement
Flush
42"
(106,7 cm)
1-1/2" (3,2 cm)
Nails
6"
(15,2 cm)
Fig. B
6"
(15,2 cm)
1-1/2" (3,2 cm)
Nails
Advertisement
Table of Contents
