Table of Contents
Advertisement
PARTS REQUIRED:
5/8 x 48 x 96"
x1
(1,6 x 121,9 x 243,8 cm)
Ensure your floor frame is square by installing one panel
and squaring frame.
BEGIN
Attach the 48 x 96" panel with the rough side up (painted-grid lines side) with the 48"
1
edge and corner flush to the floor frame (Fig A). Secure panel with two 2" nails in the
corners.
Move to the opposite side. Using the long edge of the panel as a lever, move the
2
panel side-to-side until the top corner is flush to the floor frame (Fig. B).
Secure panel with two 2" nails in the corners.
Check the floor frame is square by measuring diagonally
3
across the frame corners. If the measurements are the
same your floor frame is square. The measurement will
be approximately
Continue attaching the panel using 2" nails 6" apart on
4
edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail
into joists under panel.
Grid lines up
6"
(15,2 cm)
Seam
FLOOR PANELS
169-13/16" (431,3 cm)
Seam
12"
(30,5 cm)
144"
(365,8 cm)
DOOR
(Fig. C).
11
x50
2" (5,1 cm)
3/4"
(1,9 cm)
Fig. A
(2) Nails
(2) Nails
3/4"
(1,9 cm)
Fig. B
48"
(121,9 cm)
169-13/16"
(431,3 cm)
Flush
Flush
Flush
169-13/16"
(431,3 cm)
Fig. C
Advertisement
Table of Contents
