Table of Contents
Advertisement
PARTS REQUIRED:
x1
TEMPORARY SUPPORT
OO
1-1/2 x 2-1/2 x 69" (3,8 x 6,3 x 175,3 cm)
x1
x1
3/8 x 42 x 96"
(1 x 106,7 x 243,8 cm)
BEGIN
Attach OO as a support-ledge to to help install side wall panels. Measure down from floor 1" and mark.
1
Ensure OO is level and centered. Secure to floor joist with two 3" screws.
Place 42 x 96" panel primed side out onto OO ledge board flush with front wall stud. Ensure 1" overhang at
2
bottom of panel. Secure panel with two 2" nails in the corners (Fig. A). Ensure the measurement between
the panel edges are the same along the entire length (Fig. B). Angle nails to hit floor frame (Fig. C).
Move to the top of panel. Using the long edge of the panel as a lever move the panel side-to-side until top of
3
panel is flush with front wall stud. Secure upper corner with (1) 1-1/2" nail into rafter (Fig. D). Ensure 1" panel
overhang at bottom of panel (Fig. D).
Primed
side out
Same
Measurement
Fig. B
Flush
Flush
SIDE WALL PANELS
x1
3/8 x 42 x 96"
3/8 x 48 x 84-3/4"
(1 x 106,7 x 243,8 cm)
(1 x 121,9 x 215,3 cm)
OO
2" Nails
42"
1"
(106,7 cm)
(2,5 cm)
x2
x1
3/8 x 48 x 84-3/4"
(1 x 121,9 x 215,3 cm)
3" Screws
LEVEL
1" (2,5 cm)
Fig. A
Flush
Fig. C
OO
29
3" (7,6 cm)
x3
2" (5,1 cm)
x12
1-1/2" (3,8 cm)
1" (2,5 cm)
1-1/2" Nail
Fig. D
1"
(2,5 cm)
Advertisement
Table of Contents
