Replacing An Item; Running A Simulation - Resource Data Management PR0750-TDB Installation & User Manual

Intuitive Mercury 6-5M Controller with TDB

Replacing an Item

Running a Simulation

The application can be simulated by clicking on the Run Simulation icon in the toolbox. When running, the toolbox changes to give the following
options: -
Hovering the mouse pointer over outputs and inputs will show the value. Diagnostic analogue or digital displays are also a useful way to observe
data flow through the application.
Values can be changed dynamically while simulating by clicking the item and then changing its value
Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Select the "Replace" tab and enter the name of the item you
want to find. Enter the name you want to replace it with.
Selecting the "Replace" button will highlight the target in
yellow, clicking the "Replace" button again will change the
item's description.
If there are several items with the same name you can replace
them all with another name by selecting the "Replace All"
button.
NOTE: Only the item's name will be changed, all other
settings will remain the same.
Revision 2.6
.
Page 45 of 53
www.resourcedm.com