Set Block (Digital); Show Names; Find/Replace; Finding An Item - Resource Data Management PR0750-TDB Installation & User Manual

Intuitive Mercury 6-5M Controller with TDB

Set Block (Digital)

Icon

Show Names

Right click on the workspace and from the sub-menu select "Show Names". All TDB blocks will have their names shown above them.

Find/Replace

Finding an Item

Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Properties
Right clicking on an unused area of the workspace brings up a sub menu shown on the left,
select "Find/Replace".
Enter the name of the item you want to find, in the example below "Air Probe" and click "Find
Now".
The item being searched for will be highlighted in yellow as shown.
If the "Orphans Only" box is ticked then only items with no wires attached will be found.
Revision 2.6
Change an analogue set block to a digital set block by changing the
"Type" to "Digital". The setting icon will change to a blue colour. Check
the "Internal" box to prevent this value being displayed within the I/O
list of values.
Note: There is a maximum of 64 external setting blocks allowed in a
program. If more than 64 need to be used they would need to be set as
internal.
If the user tries to add more than 64 external an error message will pop
up
www.resourcedm.com
Page 44 of 53