Shortcuts; Split Wire; Set Block (Analogue) - Resource Data Management PR0750-TDB Installation & User Manual

Intuitive Mercury 6-5M Controller with TDB

Shortcuts

Icon

Split Wire

Setting Block 1

Set Block (Analogue)

Icon
Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Properties
Analog Display
Properties
Revision 2.6
Use shortcuts to wire 2 points together instead of a
wire.
Select "Receiver" for outputs and "Producer" for
inputs.
Once a receiver has been configured, the producer
will have a list of available receivers.
Right clicking on any wire connection will give a
"Delete wire" and "Split wire" option. Selecting the
"Split wire" will cut the wire and add a shortcut to
the two cut ends, one being a producer and one
being a receiver.
The shortcuts will be given the name similar to
the block to the left of the split "Setting Block 1" in
this case.
This will make the shortcuts have more sensible
names.
Splitting wires will make the layout simpler and
the TDB program easier to follow.
Use a set block to define values for analogue and inputs, such as
set-points.
The example shows a 20°C value.
Check the "Internal" box to prevent this value being displayed
within the I/O list of values. Use Min and Max to define limits to
which the Value can be set.
Note: There is a maximum of 64 external setting blocks allowed in
a program. If more than 64 need to be used they would need to be
set as internal.
If the user tries to add more than 64 external an error message will
pop up
www.resourcedm.com
Page 43 of 53