Intuitive Mercury 6-5M Controller with TDB
Analogue Output
Icon
Fixed Properties
Type is fixed
Board: Will be 0
Output: Will be Volts Output or mA
Output, depending on daughter board
fitted.
Analogue outputs need to be defined
"Output Mode" is fixed as V or mA
depending on daughter board fitted.
Define an input value to the block and
the output value. There are 11 define
points, and between points there is a
linear interpolation.
Digital Input
Icon
Properties
Type is Fixed
Board will be 0
Input: Select which input is to be used from
the drop-down menu (This will be one of the six probe
inputs)
Define allows the switching threshold to be changed, this is
defaulted to 1000 ohms. When the inputs detects a resistance
greater than 1000 ohms then the input is seen as open circuit, if
the input is less than 1000 ohms then it is seen as closed circuit.
Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Revision 2.6
Page 22 of 53
www.resourcedm.com