Change Over; Match Date - Resource Data Management PR0750-TDB Installation & User Manual

Intuitive Mercury 6-5M Controller with TDB

Change Over

Input
Swap
Proof 1
Proof 2
Delay

Match Date

Day
Month
Year
Warning
Ensure that all power is
switched off before
installing or maintaining
this product
Icon
Input:
Swap:
Enable 1
Fail 1
Proof 1 & 2:
Enable 2
Fail 2
Delay:
Enable 1:
Fail 1:
Enable 2:
Fail 2:
Icon
Match Date
Revision 2.6
Demand required. Either Enable 1 or 2 will be turned on
when this input is activated and will off when the input is
deactivated. The output activated will vary depending on
whether or not the Swap input has been enabled.
When activated the Enable output current operating will be
turned off and the alternative Enable output turned on
(Proof dependant). If the Swap input has never been
activated then only Enable 1 will be activated by the Input.
If used a proof signal must be returned when the
associated Enable output is activated. If the proof is
returned within the Delay parameter time the Enable output
stays on, if not the associated Enable output is turned off
and the alternative Enable output is turned on. Note If
Proof inputs are not required then a digital setting block set
to "On" must be used to bypass the Proof input('s).
Time delay associated to Proof 1&2
Digital Output.
Activated if Proof 1 is not returned within the allotted time
after Enable 1 is turned on.
Digital Output.
Activated if Proof 2 is not returned within the
allotted time after Enable 2 is turned on.
Properties
The "Match Date" output is active when the date
entered matches the Real Time Clock (RTC) within
the controller.
Day Enter a value between 1 and 31
Month Enter a value between 1 and 12
Year Enter a value between 00 and 99
Output stays on for 24 Hours until the date changes
The block can also be used in conjunction with the
Date and Time Block.
Properties
Page 33 of 53
www.resourcedm.com