Ricoh MV310 Service Manual page 108

INSTALLATION
OPTIONAL UNITS
[F]
[G]
After installing the interface unit, do the following:
•
Connect a printer cable (parallel cable) from the machine to a PC.
•
Plug in the machine and turn on the main switch.
•
Check if the On Line indicator on the operation panel is lit or not. If it is
not, check the harness connection from the printer interface unit to the
FDU.
•
Enter user function 36 and print a setup sheet or a test pattern to check
the controller. (Refer to the Operation Manual for the procedures.)
•
Print a page from the PC to check the parallel interface.
Connect the harness [E] to the FDU, and
hook up the printer interface unit [F] to
the machine.
[E]
Secure the unit with two screws, and in-
stall the side covers [G] and [H].
[H]
3-4
May 22nd, 1995
H144i505.wmf
H144i506.wmf