Ricoh MV310 Service Manual page 143

May 22nd, 1995
Communication Switch 06
No FUNCTION
Dialing requirements:
0 Germany
0: Disabled 1: Enabled
Dialing requirements: Austria
1
0: Disabled 1: Enabled
Dialing requirements:
2 Norway
0: Disabled 1: Enabled
Dialing requirements:
3 Denmark
0: Disabled 1: Enabled
Dialing requirements: France
4
0: Disabled 1: Enabled
Dialing requirements:
5
Switzerland
0: Disabled 1: Enabled
6 Not used
7
Communication Switch 07 - Not used (do not change the factory settings).
Communication Switch 08 - Not used (do not change the factory settings).
Communication Switch 09 - Not used (do not change the factory settings).
Communication Switch 0A
No FUNCTION
Point of resumption of
memory transmission upon
0 redialing
0: From the error page
1: From page 1
1 Not used
to
6
Emergency calls using 999
7 0: Enabled 1: Disabled
Communication Switch 0B - Not used (do not change the factory settings).
Communication Switch 0C - Not used (do not change the factory settings).
SERVICE TABLES AND PROCEDURES
COMMENTS
These switches are automatically set to the settings
required by each country after a country code (System
Switch 0F) is programmed.
Do not change the settings.
COMMENTS
0: The transmission begins from the page where
transmission failed the previous time.
1: Transmission begins from the first page.
Do not change the settings.
If this bit is at 1, the machine will not allow you to dial
999 at the auto-dialer. This is a PTT requirement in the
UK and some other countries.
4-35
BIT SWITCHES