Lubricating The Drive Chain - Yamaha FZ-16 2015 Service Manual

2. Rotate the rear wheel to find the point of
greater tension in the drive chain.
3. Check:
Clearance transmission chain "a"
OOS Adjust ‫.וי‬
Clearance transmission
chain:
30-40 mm
NOTE:
Measure clearance transmission chain between
the coupling pin and the rear wheel axle.
4. Fit:
Clearance of the transmission chain.
a. Loosen the nut on the brake rod "1"
b. Loosen screw "2" wheel shaft
1
c. Turn the adjusting nuts "3" to adjust the slack
chain tension specified.
Steering
The chain is tensioned
Address b
The chain is loosened
NOTE:
To maintain proper alignment of the wheel,
adjusting both sides equally.
e. Secure the axle nut with the torque wheel
specified.
Axle nut wheel:
90 Nm (9.0 m · kg, 65 ft · lb)
5. Fit:
Free pedal brake
Refer to "ADJUSTING THE REAR BRAKE"
on page 3-14
6. Align the rear axle
a. To maintain proper alignment of the shaft.
Reference lines "1" in the swingarm must
correspond with the same outer diameter of
the washer "2" on both sides.
b.
After adjusting, tighten each nut adjustment.
2
Then tighten the axle nut to the specified
torque.

LUBRICATING THE DRIVE CHAIN

The drive chain consists of many interacting
parts. If the drive chain is not properly
maintained,
maintenance to be done, particularly when the
vehicle is used in dusty areas.
We recommend using a chain cleaner and a lubricant
suitable for O-ring chains.
Recommended lubricant
Lubricant for chains with O-
ring
1.
ite all deposits of dust, dirt, mud,
or oil. during wash and air dry.
to
2.
Spray the chain with a degreaser
chain to remove fat deposition
b
for 5 minutes.
3. Clean the chain with a clean cloth and wait
3-17
CHASIS
1
2
wear quickly. Therefore,