Yamaha FZ-16 2015 Service Manual page 147

c. Align the "I" of the timing sprocket "c" with the
stationary mark "d" on the plate holding the
camshaft.
d.
Install the timing chain on the sprocket
Camshaft and then install the camshaft
sprocket on the camshaft.
NOTE:
When installing the camshaft sprocket, make
sure to keep the chain on the exhaust side as
stressed as possible.
CAUTION
Do not turn the crankshaft when installing the
camshaft to avoid damage or malfunction of the
valves.
e.
While holding the camshaft, temporarily
tighten the screw shaft sprocket camshaft.
f. Remove the cable from the distribution chain.
4.
Install:
Tensioner Gasket chain
•
•
Tensor distribution chain
a.
While pressing gently rod
chain tensioner distribution with
hand, turn it clockwise with a thin screwdriver
"1".
b.
With tensor rod distribution chain completely
rotated in the box
tensor of the distribution chain (With
the screwdriver still installed), install
tensor packaging and distribution chain "2" in
the body of the cylinder.
b
to
d
c
New
5-10
c. tighten the tensioner timing chain "3" to the
specified torque.
Screws chain tensioner distribution
9 Nm (0.9 m · kg, 7 ft · lb)
2
1
d.
Remove the screwdriver, make sure the rod
chain tensioner return distribution.
5.
Turn:
• Crankshaft
(Several times clockwise)
6.
Check:
• "I" mark "a"
Align the "I" of the magnet with the brand
stationary "b" in the magneto cover.
•
"I" mark "c"
Align the "I" of the camshaft sprocket with the
stationary mark "d" in the butt.
Out of alignment Correct ‫וי‬
See previous assembly steps.
CULATA
1
3
b
to