CLUTCH REMOVAL
1.
Straighten the lock washer.
2.
Loosen:
•
The clutch disc holder nut "1"
NOTE:
While holding the tray clutch "2" with the clutch
holder "3", loosen the nut on the clutch disc
holders.
Clutch Holder
YSST-733
2
INSPECTION OF RECORDS OF FRICTION The
following procedure applies to all friction discs.
1.
Check:
•
Friction disc
Damage / wear Replace ויdiscs
friction as a whole.
2.
2.
Measure:
•
Thickness of the friction plates
OOS Replace ויthe
friction disks as an assembly.
NOTE:
Measure the friction plates in four places.
Thickness of the friction plates
1 & 2
2.90-3.10 mm
Wear limit
2.80 mm
A
1
3
A.
Friction Disc 1
B. Friction Disc 2
B.
X
= The space between the friction material
coating on the friction disc 1.
And
= The space between the friction material
coating on the friction disc 2.
NOTE:
The space X must be less than the disc space
and one friction and friction disc 2, respectively.
CHECKING THE CLUTCH DISCS
The following procedure applies to all the clutch
plates.
1.
Check:
•
Clutch disc
Damage / wear Replace ויdiscs
clutch as a whole.
2.
Measure:
(With a surface plate and thickness gauge "1")
Out of Specification וי
Replace the clutch plates as a set
5-38
EMBRAGUE
B
XY
Deformation of the clutch plates
•