NOTE:
While holding the damper rod with the clip of the
damper rod "2" and the T-wrench "3", loosen
the damper rod.
Key in T
YSST-813
CHECKING THE FRONT FORK BARS
The following procedure applies to both front fork
legs
1.
Check:
•
Inner tube
Outer tube
•
Curves / damage / scratches Replace
.וי
WARNING
Do not attempt to straighten a bent inner tube as
dangerously weakened
2.
Measure:
•
Spring free length "a"
OOS Replace .וי
Spring Free Length
254.4 mm
HORQUILLA DELANTERA
3.
Check:
•
Damper rod
Damage / wear Replace .וי
Obstructed Blow compressed air ויall
oil passages
•
Oil flow stopper
Impaired Replace .וי
CAUTION
When disassembling and assembling the front
fork legs, perrmita no foreign materials enter the
front fork.
BARS ASSY FRONT FORK
The following procedure applies to both front fork
legs
WARNING
Make sure the oil levels in both front fork legs
are equal
Different oil levels can result in little loss of
maneuverability and stability.
NOTE:
•
During assembly of the front fork legs, be sure to
replace the following parts:
- Bushing outer tube
- Oil Seal
- Dust
- Clip
•
Before assembling the front fork legs, make sure
all components are clean.
1.
Assemble:
Damper rod
•
CAUTION
Allow the damper rod to slide slowly down
the inner tube until it protrudes from the
bottom of the inner tube. Be careful not to
damage the inner tube.
2.
Lubricate:
•
Outer surface of the inner tube
4-39