Checking The Engine Oil Level; Engine Oil Change - Yamaha FZ-16 2015 Service Manual

Compression pressure (with oil applied into
the cylinder)
Reading
Piston rings are worn or
Greater than without damaged ‫וי‬
oil
Repair
Oil-like
7. Remove:
Gauge
8. Assemble:
Spark.
Plug
13 Nm (1.3 m · kg, 9.4 ft · lb)
9. Connect:
Spark plug cap.

CHECKING THE ENGINE OIL LEVEL

1. Place the vehicle on a flat surface.
Note:
Place the vehicle on the center stand. Make
sure the vehicle is vertical.
2.
Start the engine, warm it up for several minutes
and then shut.
3.
Check:
Engine oil level.
The engine oil level should be between the
minimum level "a" peak "b"
Below the minimum level mark, add engine oil
of the recommended type to the specified
level.
Note:
Before checking the engine oil level, wait a few
minutes until the oil has settled.
Do not screw the dipstick "1" when
Check the oil level.
1
Diagnosis
Piston, valves, cylinder
head gasket possibly
d e f e c t i v e ‫וי‬
Repair / replace
1
to
b
Type
SAE 20W50 (Engine Oil
YAMALUBE-4 times)
CAUTION
Do not allow foreign matter entering the
crankcase.
4. Start the engine, warm it up for several minutes
and then shut.
5. Check the engine oil level again.
NOTE:
Before checking the engine oil level, wait a few
minutes until the oil has settled.

ENGINE OIL CHANGE

1. Start the engine, warm it up for several minutes
and then shut.
2. Place a container under the oil drain screw
motor.
3. Remove:
Gauge Engine oil level "1". Plug "2".
1
2
4. Drain:
Motor oil
(Completely c r a n k c a s e ) .
5. If the oil filter element should also be replaced,
proceed as follows.
a. Remove the cover from the oil filter element "1"
and the oil filter element "2".
b. Install new O-Rings "3"
2 New
3-9
MOTOR
3
1