Clearance Adjusting The Drive Chain - Yamaha FZ-16 2015 Service Manual

1.
Remove:
Cover the brake master cylinder "1"
NOTE:
Be careful not to spill brake fluid and do not let the master cylinder
reservoir overflow.
When you bleed the brake hydraulic system,
make sure there is always enough brake fluid
before toggling. If this precaution is ignored, may
occur in the air inlet hydraulic brake system,
greatly increasing the purge procedure time.
If bleeding is difficult, it may be necessary to let
the brake fluid settle for a few hours. Repeat
when small air bubbles are gone.
2. Bleed:
Hydraulic Brake System
a. Fill the brake fluid reservoir to the proper level
with the recommended brake fluid.
b.
Assemble reservoir diaphragm brake master
cylinder.
c.
Securely attach clear plastic hose "1" in the
bleed screw 2.
1
d.
Place the other end of the hose into a
container.
e.
Slowly actuate the brake lever several times.
f.
Pull the lever fully without releasing brake
g.
NOTE:
When you release the bleed screw, the pressure
will be released and cause contact with the brake
lever the throttle.
1
h.
i.
j.
k.
After making the bleed hydraulic brake system,
check the brake operation.
3.

CLEARANCE ADJUSTING THE DRIVE CHAIN

NOTE:
The slack of the drive chain must be verified at
the point of greatest stress.
CAUTION
A string stretched excessively load the engine
and other vital parts and a loose chain can go out
and damage the swingarm or cause an accident.
2
Therefore,
transmission chain within specification limits.
1.
Securely support the vehicle so there is no risk of
falling.
NOTE:
Place the vehicle on the main stand, so that the
rear wheel is elevated.
3-16
Loosen the bleed screw.
Tighten the bleed screw and then release the
brake lever
Repeat steps "e" to "h" until all air bubbles
have disappeared brake fluid in the plastic
hose.
Tighten the drain plug to the specified torque.
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)
Fill the brake fluid reservoir to the proper level
with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-14
WARNING
Assembly:
Cover the brake master cylinder
maintaining the
Place the vehicle on a flat surface
WARNING
CHASIS
tension of the