Removing The Power Unit - Barco ILite 6 Service Manual

5. Tile disassembling
5.5

Removing the power unit

The power unit can be removed without removing the power assembly out of the ILite tile. Only the tile cover
has to be removed first.
Necessary tools
• Torx T20.
• 7 mm nut driver.
How to remove the power unit from the power support plate ?
1. Disconnect the wire unit of the fan from the power unit.
Image 5-5
2. Is the power assembly removed from the ILite tile?
If yes, release the four screws (P) which attach the power unit (J) to the power support plate (I). One screw in each corner of the
power unit.
Note: The screw in the bottom left corner, nearby the power socket of the power unit, contains a toothed lock washer (O). Do
not lose this washer. You will need it when you reinstall the power unit. This lock washer ensures a good grounding
between the power unit and the rest of the tile.
Image 5-6
If no, release the seven screws (P) which attach the power unit to the power support plate and the module base plate. Three at
the left side, three at the right side and one at the bottom side of the power unit.
Caution: Be careful with the board to board connectors between the power unit and the controller unit underneath.
24
I
J
P
O
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007