Table of Contents
Advertisement
A. On screen display messages
A.1 OSD messages
Some of the OSD messages listed below can be displayed on request via the XLite toolset.
List with OSD messages for ILite 6/8/10/12 tiles
OSD message
ACONT
100
100
100
ADDR
26
CALI
BRATE
BUSY
CALI
BRATE
DONE
COLOR
VALUE
ERROR
CONTR
MIS-
MATCH
DCONT
100
100
100
ERROR
LINK
← & →
ERROR
NO
LINK
← / →
FAN
SPEED
70%
FIRM
A1.04
B1.02
C1.20
60
Description
Displaying the RGB values set for analog contrast. These values are factory pre-adjusted.
Displaying tile address. Note that all devices in the data chain has an address number, starting with the
master digitizer having address "1". The address number increments for all following devices in the
data chain. Each digitizer, fiberlink transmitter, fiberlink receiver, AEC and all tiles in the data chain are
considered as a device with a unique address.
Calculating the calibration values.
Calibration process done.
Wrong measurement values stored. Tile needs to be re-measured in factory.
Gives warning that LMT-saved analog contrast differs from current contrast.
Displaying the RGB values set for digital contrast. These values can be changed between 0 and
255 using the XLite toolset.
"LINK" signal (sync) detected from left and from right.
No "LINK" signal (sync) detected.
Displaying the fan speed, in percents, of the internal fan of the ILite tile.
Displaying firmware version of the re-sync unit (second line), firmware version controller (third line) and
the firmware version of the driver (fourth line).
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007
Advertisement
Table of Contents
Troubleshooting
