6. Tile reassembling
6.6
Installing the fan
The power support plate has to be detached from the tile before you can install the fan.
Necessary tools
Phillips screwdriver H2.
Necessary parts
•
Four cross head cutting screws 3 x 16 mm.
•
Four small rubber grommets.
How to install the fan upon the power support plate ?
1. Check if the mounting holes for the fan on the power support plate (I) are provided with buffing grommets (S). If not, insert the
grommets as illustrated.
Image 6-9
2. Place the fan (K) upon the power support plate (I) with the engine at the right side as illustrated.
T
Image 6-10
3. Fasten the fan with four cross head cutting screws (T).
4. Is the power unit already attached to the power support plate ?
If yes, plug the wire unit of the fan into the socket on the power unit. Ensure to guide the wire unit through the two cable holders
on the support plate, see illustration.
40
I
S
I
K
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007