Removing The Re-Sync Unit - Barco ILite 6 Service Manual

5. Tile disassembling
5.1

Removing the re-sync unit

Necessary tools
Slot screwdriver (100 x 4 mm).
How to remove the re-sync unit ?
1. Release the two captive screws of the re-sync unit (M) using a slot screwdriver.
Image 5-1
2. Pull out the re-sync unit.
Caution: Be careful with the board to board connectors between the re-sync unit and the controller unit underneath.
The data cables connected with the re-sync unit may stay connected while removing the re-sync unit to per-
form a hot swap of the ILite tile.
20
M
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007