Barco ILite 6 Service Manual page 65

OSD message
FIRM
ERROR
B1.02
C1.20
I2C-
ERROR
EEPR.
CTRL.
I2C-
ERROR
EEPR.
LED.
I2C-
ERROR
RE-
SYNC.
I2C-
ERROR
SENSE
CTRL.
I2C-
ERROR
SENSE
DRIVE
HPOS
144
→
216
LED-
BOARD
MIS-
MATCH
→LINK
→LINK
DUAL
→LINK
NO
DATA
→LINK
ERROR
DATA
← & →
Meas.
Nr.
17
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007
Description
Unable to read the firmware version of the re-sync unit (second line).
Displaying firmware version controller (third line) and the firmware version of the driver (fourth line).
I C error occurred while reading the EEPROM on the controller unit.
2
I C error occurred while reading the EEPROM on one of the LED drivers.
2
I 2 C error occurred while reading info on the re-sync unit.
I C error occurred while reading info on the temperature sensors of the controller unit.
2
I 2 C error occurred while reading info on the temperature sensors of the LED drivers.
Displaying the start pixel row and end pixel row of the tile in the complete LED-wall. The origin is
always left top of the display.
Gives warning that LED-modules has different serial numbers than the ILite tile.
Displaying the direction of "LINK" signal (sync) and "DATA" signal (video content). The arrow can
point to the left or to the right.
Displaying the direction of "LINK" signal (sync) and "DATA" signal (video content). The arrow can
point to the left or to the right. Dual path detected.
Displaying the direction of "LINK" signal (sync). The arrow can point to the left or to the right.
No data detected.
Displaying the direction of "LINK" signal (sync). The arrow can point to the left or to the right.
Data detected from left and from right.
Displaying detected measurement system.
A. On screen display messages
61