Barco ILite 6 Service Manual page 60

7. Maintenance
Image 7-5
2. Clean the solder paths. Do this using a solder removing wick and flux.
Note: If a solder path is ripped of it is not possible to mount a new LED. This can happen when a LED board is physical damaged
(specially the corners).
Image 7-6
3. Place the mould and the new LED on the LED module in such a position that two pins of the new LED are accessible and the
new LED has the same orientation as all other mounted LED's.
Caution: Make sure that the new LED is correctly aligned with the same orientation as all other LED's on the LED module.
Note: One corner of the LED has a chamfer which indicates the common anode pin. The LED's used for the ILite 6 BK have a
black package. This package makes it difficult to see the chamfer.
LED ILite 6 XP
Chamfer
Image 7-7
56
Common
Anode
Mould
R5976865 ILITE 6/8/10/12 DISPLAY 14/12/2007
Stick