Table of Contents
Advertisement
Helix 5 Device.fm Page 20 Tuesday, June 5, 2007 5:24 PM
need to clear the key first (see "Clearing a Macro Key" on
page 20).
Programming a Macro Key
On the remote control, press and hold SETUP
1.
until it blinks twice.
Enter 9 9 5. The SETUP key blinks twice.
2.
Select a macro key (for example, 1) and press
3.
it once.
4.
Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press TV followed by
VOL+.
NOTE:
You can program up to 15 key presses into one
macro.
5.
Press and hold SETUP until it blinks twice.
6.
To add another macro, repeat steps 1 through
5, substituting the new key sequence to be
added in step 4.
NOTE:
Programming more than five macros on the
same macro key overwrites previous settings.
Clearing a Macro Key
1.
On the remote control, press and hold SETUP
until it blinks twice.
2.
Enter 9 9 5. The SETUP key blinks twice.
3.
Press the macro key you want to clear once.
Press and hold SETUP until it blinks twice.
4.
This macro key is now clear and ready for
reprogramming (see "Programming a Macro Key" on
page 20). If desired, repeat these to clear another Tune-
In key.
www.urcsupport.com
20
Advertisement
Table of Contents
