Removing A Node From A Scene; Deleting A Scene; Controlling Scenes - Universal Electronics Helix Z-wave User Manual

Helix 5 Device.fm Page 25 Tuesday, June 5, 2007 5:24 PM

Removing a Node from a Scene

1. Press HOME once.
2. Press REMOVE once.
3. Press SCENE once.
4. Press a digit (1-9) for the node location you
wish to remove. The red LED blinks rapidly.
5. Press the button on the node so that it sends
its information to the remote and receives
information from the remote.
6. The green LED blinks twice, then the red LED
blinks rapidly.
NOTE: If the red LED emits one long, steady blink, you
have pressed an invalid key or the node has not
been successfully removed from the scene.

Deleting a Scene

1. Press HOME once.
2. Press DELETE once.
3. Press SCENE once.
4. Press a digit (1-9) for the scene you wish to
remove.
5. Press the button on the node so that it sends
its information to the remote and receives
information from the remote.
6. The green LED blinks twice. The scene has
been removed successfully.
NOTE: If the red LED emits one long, steady blink, you
have pressed an invalid key or the scene has not
been successfully deleted.

CONTROLLING SCENES

To control a scene, perform the following steps:
1. Press HOME once.
2. Press the digit key for the scene you wish to
control (1-9).
3. Press the ON, OFF, DIM, or BRIGHT key. The
green LED blinks once.
If ON or OFF is pressed, all nodes associated
to the scene turn on or off. If DIM or BRIGHT
is pressed, all nodes associated with a scene
dim or brighten with each key press.
NOTE: If the red LED emits one long, steady blink, the
remote has not successfully communicated with the
node.
Turning All Nodes On or Off
www.urcsupport.com
25