Transferring Node And Network Information To A Secondary Remote - Universal Electronics Helix Z-wave User Manual

Helix 5 Device.fm Page 26 Tuesday, June 5, 2007 5:24 PM
To turn all nodes either on or off, perform the following
steps:
1. Press HOME once.
2. Press ALL once.
Press either ON to turn the nodes on, or OFF to
3.
turn the nodes off. Any ON or OFF can be
pressed. The green LED blinks once.
NOTE: If the red LED emits one long, steady blink, you
have pressed an invalid key or the All-On/All-Off
command was not successful. Repeat the steps
above to try again.
Adding Nodes to All Control
1. Press HOME once.
1. Press ADD once.
2. Press ALL once. The red LED blinks rapidly.
3. Press the button on the node so that it sends
its information to the remote and receives
information from the remote.
4. The green LED blinks twice. The node has
been successfully added.
NOTE: If the red LED emits one long, steady blink, the
node has not been successfully added to the group.
Deleting Nodes from All Control
1. Press HOME once.
Press REMOVE once.
1.
2. Press ALL once. The red LED blinks rapidly.
3. Press the button on the node so that it sends
its information to the remote and receives
information from the remote.
4. The green LED blinks twice. The node has
been successfully deleted.
NOTE: If the red LED emits one long, steady blink,
the node has not been successfully added to
the group.
TRANSFERRING NODE AND NETWORK
INFORMATION TO A SECONDARY REMOTE
You can add a secondary remote to your network, and
transfer your primary remote's node and network
information to it. To transfer node and network
information to a secondary remote, perform the
following steps:
1. Place the two remotes near each other.
2. Press HOME.
www.urcsupport.com
26