Programming a Macro Key
1.
On the remote control, press and hold SETUP
until it blinks twice.
2.
Enter 9 9 5. The SETUP key blinks twice.
3.
Select a macro key (for example, F1) and
press it once.
4.
Press the key sequence you want to program
into the macro. For example, to turn on your
TV and raise its volume, press TV followed by
VOL+.
NOTE:
You can program up to 15 key presses into one
macro.
5.
Press and hold SETUP until it blinks twice.
6.
To add another macro, repeat steps 1 through
5, substituting the new key sequence to be
added in step 4.
NOTE:
Programming more than five macros on the
same macro key overwrites previous settings.
Clearing a Macro Key
1.
On the remote control, press and hold SETUP
until it blinks twice.
2.
Enter 9 9 5. The SETUP key blinks twice.
3.
Press the macro key you want to clear once.
4.
Press and hold SETUP until it blinks twice.
This macro key is now clear and ready for
reprogramming (see "Programming a Macro Key" on
page 21). If desired, repeat these to clear another Tune-
In key.
www.urcsupport.com/atlasocap
21