Table of Contents
Advertisement
Helix 5 Device.fm Page 28 Tuesday, June 5, 2007 5:24 PM
PRIMARY CONTROLLER SHIFT
You can transfer all of your remote's information to
another remote, so it becomes the new primary remote.
You can do this in two ways: either transferring all
information, or just transferring network information.
Transferring All Network and Remote Information
1.
Place the two remotes near each other.
2.
Press HOME.
3.
Press and hold SETUP until the red LED blinks
twice.
4.
Enter 9 6 8 on the numeric keypad. The red
LED blinks twice.
5.
Press CH+. The red LED blinks rapidly.
6.
Put the target (secondary) remote into
programming mode so that it sends its
information to the primary remote, as well as
receives information from the remote. The
remote then transfers the network and node
information to the new secondary remote.
Refer to the user manual for the secondary
remote for more information.
7.
The green LED blinks twice. You have
successfully transferred the information.
NOTE: If the red LED emits one long, steady blink, the
information has not been successfully transferred.
8.
Add nodes, groups, and scenes to the new primary
remote as needed.
Transferring Only Network Information
1.
Place the two remotes near each other.
2.
Press HOME.
3.
Press and hold SETUP until the red LED blinks
twice.
4.
Enter 9 6 6 on the numeric keypad. The red
LED blinks twice.
5.
Press CH-. The red LED blinks rapidly.
6.
Put the target (secondary) remote into
programming mode so that it sends its
information to the primary remote, as well as
receives information from the remote. The
remote then transfers the network and node
information to the new secondary remote.
Refer to the user manual for the secondary
remote for more information.
7.
The green LED blinks twice. You have
successfully transferred the information.
www.urcsupport.com
28
Advertisement
Table of Contents
