Table of Contents
Advertisement
Helix 5 Device.fm Page 29 Tuesday, June 5, 2007 5:24 PM
NOTE:
If the red LED emits one long, steady blink,
the information has not been successfully
transferred.
8.
Add nodes, groups, and scenes to the new
primary remote as needed.
CONTROLLER COPY RECEIPT
Controller Copy Receipt allows your controller to receive
information from another controller. This would then
allow the unit to become a new primary or secondary
controller.
Copying Information from Another Controller
1.
Place the two remotes near each other.
2.
Press HOME.
3.
Press and hold SETUP until the red LED blinks
twice.
4.
Enter 9 6 7 on the numeric keypad. The red
LED blinks twice.
Press CH-. The red LED blinks rapidly.
5.
6.
Put the target (secondary) remote into
programming mode so that it sends its
information to the primary remote, as well as
receives information from the remote. The
remote then transfers the network and node
information to the new secondary remote.
Refer to the user manual for the secondary
remote for more information.
7.
The green LED blinks twice. You have
successfully transferred the information.
NOTE:
If the red LED emits one long, steady blink,
the information has not been successfully
transferred.
8.
Add nodes, groups, and scenes to the new
primary remote as needed.
NETWORK RESET
Network Reset clears all Node and Network features.
The remote resets to the default setting for the Z-wave
network and node information.
Resetting the Network
1.
Press HOME.
2.
Press and hold SETUP until the red LED blinks
twice.
3.
Enter 9 6 9 on the numeric keypad. The red
LED blinks continuously.
www.urcsupport.com
29
Advertisement
Table of Contents
