Setting Up A Combo Unit - Universal Electronics Helix Z-wave User Manual

Helix 5 Device.fm Page 11 Tuesday, June 5, 2007 5:24 PM

SETTING UP A COMBO UNIT

If you own a combo unit such as a TV/VCR Combo or a
TV/DVD Combo, you need to follow special steps to set
it up. Perform the following instructions to control
combo device:
1. For a TV/VCR Combo, turn on your TV/VCR
Combo and insert a video cassette. (For a TV/
DVD Combo, insert a DVD).
On the remote control, press DVD/VCR once; it
2.
will blink once. Then press and hold SETUP
until the DVD/VCR key blinks twice.
3. Use the "Manufacturer's Codes" starting on
page 34 to locate the brand name and enter
the first four-digit code for your combo device
(for example, TV/VCR). If you perform this
procedure correctly, the DVD/VCR key will
blink twice.
NOTE: If the DVD/VCR key did not blink twice after
entering the codes last digit, repeat steps 2
through 3 and try entering the same code
again.
If you've located a setup code that works for
your combo device (for example, a TV/VCR
Combo) and a separate TV code is also listed,
you'll need to program this code into the
remote control to access volume control (see
"Programming Device Control" starting on
page 9).
4. Aim the remote control at your combo device
(for example, TV/VCR Combo) and press
PWR once. The device should turn off. If it
does not respond, repeat steps 2 through 3,
trying each code listed for your brand until
you find one that works. If it still does not
respond, try searching for the code
("Searching for Your Code" starting on
page 12).
5. For future reference, write down each working
device code in the boxes below:
TV/VCR or TV/DVD Code
TV Code (if used)
www.urcsupport.com
11