Table of Contents
Advertisement
Helix 5 Device.fm Page 12 Tuesday, June 5, 2007 5:24 PM
SEARCHING FOR YOUR CODE
If your home entertainment device does not respond to
the Helix Z-wave 5-Device Remote Control with
Learning after trying all of the codes listed for your
brand, or if your brand is not listed at all, try searching
for your code.
For example, to search for a code for your TV:
1.
Turn on your TV.
On the remote control, press TV once; it will
2.
blink once. Then press and hold SETUP until
the TV key blinks twice.
Enter 9 9 1. The TV key will blink twice.
3.
4.
Aim the remote control at the TV and press
PWR once.
5.
Press and release the CH+ key continuously,
then stop when the TV turns off.
NOTE:
In the search mode, the remote control will
send IR codes from its library to the selected
device, starting with the most popular code
first.
6.
Press PWR. The TV should turn on, then press
SETUP to lock in the code.
NOTE:
If the TV does not turn on during step 6, then
slowly press and release CH- to go back
through the codes, then press SETUP when the
TV turns on.
7.
To search for the codes of your other devices,
repeat steps 1 through 6, but substitute the
appropriate key (e.g., VCR, DVD, AMP, or SAT)
for the device you are searching for.
www.urcsupport.com
12
Advertisement
Table of Contents
