Setting Up A Combo Unit; Searching For Your Code - Universal Electronics Potenza ST Manual

SETTING UP A COMBO UNIT

If you own a combo unit such as a TV/VCR Combo or a TV/DVD Combo, you need to follow special steps to set it up.
Perform the following instructions to control combo device:
1. For a TV/VCR Combo, turn on your TV/VCR Combo and insert a video cassette. (For a TV/DVD Com bo, inser t
a DVD).
2. On the remote control, press
key blinks twice.
3. Use the "Manufacturer's Codes" starting on page 17 to locate the brand name and enter the first four-digit code
for your combo device (for example, TV/VCR). If you perform this procedure correctly, the VCR key w ill blink
twice.
NOTE: If the VCR key did not blink twice after entering the codes last digit, repeat steps 2 through 3
and try entering the same code again. If you've located a setup code that works for your combo device (for
example, a TV/VCR Combo) and a separate TV code is also listed, you'll need to program this code into
the remote control to access volume control ( see "Programming Device Control" starting on page 8).
4. Aim the remote control at your combo device (for example, TV/VCR Combo) and press POWER once. The
device should turn off. If it does not respond, repeat steps 2 through 3, trying each code listed for your brand until
you find one that works. If it still does not respond, try searching for the code ("Searching for Your Code" starting
on page 9).
5. For future reference, write down each working device code in the boxes below:
TV Code
Device Type:
Code

SEARCHING FOR YOUR CODE

If your home entertainment device does not respond to the Potenza ST Universal Remote Control after trying all of the
codes listed for your brand, or if your brand is not listed at all, try searching for your code. For example, to search for a
code for your TV:
1. Turn on your TV.
2. On the remote control, press
blinks twice.
3. Type 9 9 1 . The TV key will blink twice.
4. Aim the remote control at the TV and press POWER once.
5. Press and release the
NOTE: In the search mode, the remote control will send IR codes from its library to the selected device,
starting with the most popular code first.
6. Press POWER . The TV should turn on, then press SETUP once to lock in the code. The LED will blink
twice to indicate that the code is saved.
NOTE: If the TV does not turn on during step 6, then slowly press and release CH- to go back through
the codes, then press SETUP when the TV turns on.
7. To search for the codes of your other devices, repeat steps 1 through 6, but substitute the appropriate key (e.g.,
TV, AUD, DVD, AUX, or STB ) for the device you are searching for.
VCR once; it will blink once. Then press and hold SETUP until the VCR
TV/VCR Code
TV once; it will blink once. Then press and hold SETUP until the TV key
CH+ key continuously, then stop when the TV turns off.
TV/DVD Code
9