Table 20: Routing Engine Status After Upgrading And Rebooting Both Routing - Juniper EX9200 Features Manual

Copyright © 2017, Juniper Networks, Inc.
Saving the config files ...
NOTICE: uncommitted changes have been saved in
/var/db/config/juniper.conf.pre-install
Installing the bootstrap installer ...
WARNING: A REBOOT IS REQUIRED TO LOAD THIS SOFTWARE CORRECTLY. Use the
WARNING: 'request system reboot' command when software installation is
WARNING: complete. To abort the installation, do not reboot your system,
WARNING: instead use the 'request system software delete jinstall'
WARNING: command as soon as this operation completes.
Saving package file in /var/sw/pkg/jinstall64-14.1R4.10-domestic-signed.tgz
...
Saving state for rollback ...
ISSU: Old Master Upgrade Done
ISSU: IDLE
Shutdown NOW!
[pid 10149]
{backup}
user@host>
{backup}
user@host>
*** FINAL System shutdown message from user@host ***
System going down IMMEDIATELY
Connection closed by foreign host.
When the Routing Engine that was previously the master is rebooted, you are logged
out of the device.
Wait a few minutes and then log in to the device again.
3.
Table 20 on page 197
Table 20: Routing Engine Status After Upgrading and Rebooting Both
Routing Engines
RE0
Backup
New software version installed
New software version running
You are logged in to the new backup Routing Engine (
Verify that both Routing Engines have been upgraded by using the
4.
command.
{backup}
user@host> show version invoke-on all-routing-engines
re0:
--------------------------------------------------------------------------
Hostname: host
shows the Routing Engine status after the unified ISSU.
RE1
Master
New software version installed
New software version running
Chapter 17: Performing a Unified ISSU
).
re0
show version
197