Modifying The Advertisement Interval In Seconds; Modifying The Advertisement Interval In Milliseconds - Juniper EX9200 Features Manual

High Availability Feature Guide for EX9200 Switches

Modifying the Advertisement Interval in Seconds

Modifying the Advertisement Interval in Milliseconds

136
NOTE: The master VRRP for an IPv6 router must respond to a router
solicitation message with the virtual IP address of the router. However, when
the
interface interface-name
router-advertisement]
might send a response before the VRRP master responds, so that the default
route of the client is not set to the master VRRP router's virtual IP address.
To avoid this situation, include the
protocols router-advertisement interface interface-name]
this statement is included, router advertisements are sent only for VRRP IPv6
groups configured on the interface (if the groups are in the master state).
You must include this statement on both the master and backup VRRP for
IPv6 routers.
This topic contains the following sections:
Modifying the Advertisement Interval in Seconds on page 136
Modifying the Advertisement Interval in Milliseconds on page 136
To modify the time, in seconds, between the sending of VRRP advertisement packets,
include the
advertise-interval
advertise-interval seconds;
The interval can be from 1 through 255 seconds.
You can include this statement at the following hierarchy levels:
[edit interfaces interface-name unit logical-unit-number family inet address address
vrrp-group group-id]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number family inet address address vrrp-group group-id]
NOTE: When VRRPv3 is enabled, the
used to configure advertisement intervals. Instead, use the
statement to configure advertisement intervals.
To modify the time, in milliseconds, between the sending of VRRP advertisement packets,
include the fast-interval statement:
fast-interval milliseconds;
The interval can be from 10 through 40,950 milliseconds.
statement is included at the
hierarchy level, the backup VRRP for an IPv6 router
virtual-router-only
statement:
advertise-interval
Copyright © 2017, Juniper Networks, Inc.
[edit protocols
statement at the
[edit
hierarchy level. When
statement cannot be
fast-interval