Nonstop Active Routing Protocol And Feature Support; Table 6: Nonstop Active Routing Protocol And Feature Support - Juniper EX9200 Features Manual

Table 5: Nonstop Active Routing Platform Support (continued)
Platform
EX Series or QFX Series switches in a Virtual Chassis Fabric

Nonstop Active Routing Protocol and Feature Support

Table 6: Nonstop Active Routing Protocol and Feature Support

Protocol
Aggregated Ethernet interfaces with Link Aggregation Control Protocol
(LACP)
Bidirectional Forwarding Detection (BFD)
For more information, see "Nonstop Active Routing BFD Support" on
page 44.
BGP
For more information, see "Nonstop Active Routing BGP Support" on
page 45.
Labeled BGP (PTX Series Packet Transport Routers: only)
IS-IS
LDP
LDP-based virtual private LAN service (VPLS)
LDP OAM (operation, administration, and management) features
Copyright © 2017, Juniper Networks, Inc.
NOTE: All Routing Engines configured for nonstop active routing must be
running the same Junos OS release.
Table 6 on page 41 lists the protocols that are supported by nonstop active routing.
Chapter 8: Nonstop Active Routing System Requirements
Junos OS Release
13.2X51-D20 or later for the EX Series and QFX
Series switches
Junos OS Release
9.4 or later
8.5 or later
8.4 or later
12.1R4 or later
8.4 or later
8.4 or later
9.3 or later
9.6 or later
41